Bosch Appliances manual MIC 500 Series Camera Quick Start Guide

4 en MIC 500 Series Camera Quick Start GuideMIC Series 500 Camera

1	MIC 500 Series Camera Quick Start Guide
	CAUTION!
	To reduce the risk of electrical shock, disconnect power supply before opening the power
	supply unit.
	Power disconnect: power supply units have power supplied whenever the power cord is
	inserted into the power source.
	WARNING!
	Installation should be carried out by qualified personnel only in accordance with the
	applicable local codes.
	Bosch Security Systems Inc. accepts no liability for any damages or losses caused due to
	incorrect or improper installation.
1.1	MIC 500 Series Camera Mounting Instructions
	The upright unit can be mounted with the camera ball up or down.
	For inverted units, first remove the four M3 x 6 screws fixing the rain shield to the face of the
	camera, reverse the rain shield, reattach it to ensure that the rain shield is oriented correctly,

and then configure the camera for inverted operation. For further details of configuring and reversing the controls for inverted units using the MIC Series Universal Camera Setup Software (cam-set) or via the MIC 500 Series camera on-screen menu, please refer to the Help and Instruction file in cam-set.

The MIC 500 Series camera, when canted, is designed only to be mounted ball up. The tilt limits for the canted unit prevent it from working properly if mounted ball down. Do not manually back drive the pan or tilt axis by hand. Back driving may strip teeth off the internal gears and in so doing will void the warranty.

M8 Stainless steel nuts, bolts, and washers should be used to secure the base to the mounting surface. Suitable sealant or the Nebar gasket may be used between the camera base and the mounting surface.

Ensure that the 12-pin connector is located inside the camera base plug and that the lock ring is tightened. Ensure that the base compartment containing the 12-way connector is moisture proof. On inverted units, it is very important that the connector area is watertight to prevent water pooling around the connector.

Figure 1.1 MIC 500 Series camera mounting positions: Inverted, Upright, and Canted

F.01U.173.601 2.0 2010.11 User’s Manual Bosch Security Systems, Inc.