en
Rinse aid %
As soon as the
The rinse aid is required for
Combined detergents with
3.7mmol/l) only. If the water hardness is over 21° dH, rinse aid must be used.
–Open the dispenser 1j by pressing and lifting the plate on the cover.
–Carefully pour rinse aid up to the max. mark in the filler opening.
–Close cover until it clicks shut.
–To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from §:‹‹ to §:‹‡. Please set rinse aid on §:‹† to obtain very good drying results (§:‹† is already set in factory).
Change this setting, only if streaks (select lower setting) or water stains (select higher setting) are left on the utensils.
–Close the door.
–Switch on ON/OFF switch (.
–Press and hold down the START button @.
–Rotate programme selector 8 until §:‹... s indicated on the digital display H.
–Release button.
The factory set value §:‹† is lit on the digital display H.
To change the setting:
–Rotate programme selector 8 until
the required value is indicated on the digital display H.
–Press START button @. The set value is saved.
Switching off rinse aid refill indicator
If the
–Proceed as described under “Setting
amount of rinse aid” and set the value to §:‹‹.
The rinse aid refill indicator ` is now switched off.
8