Warmctionemwaterrawater connection
* depending on model
The dishwasher can be connected to cold or hot water up to max. 60 °C.
Connection to hot water is recommended if the hot water can be supplied
by energetically favourable means
and from a suitable installation, e. g. solar heating system with circulation line.
This will save energy and time.
The hot water setting ‘:‹‚ allows you to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C.
It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler.
Setting hot water:
–Close the door.
–Switch on ON/OFF switch (.
–Press and hold down the START button @.
–Rotate programme selector 8 until ‘:‹‚ is indicated on the digital display H.
–Release button.
The
To change the setting:
–By rotating the programme
selector 8, you can switch the hot water setting off ‘:‹‹ or on ‘:‹‚.
–Press START button @. The set value is saved.
en
Electrical connection
–Connect the appliance to an alternating current only, ranging from 220 V to 240 V and 50 Hz or 60 Hz via a correctly installed socket with
protective earth conductor. See rating plate for required fusing 92.
–The socket must be near the appliance and freely accessible following installation.
If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions.
–The connection may be modified by technicians only.
–A power cord extension may be purchased from customer service only.
–Use only a residual current operated
the symbol ‚. Only this extension guarantees compliance with
the currently valid regulations.
–The appliance features a water damage protection system. Please note the system will not function unless the power supply is connected.
Removing the appliance
Also observe the sequence of worksteps here.
–Disconnect the appliance from the power supply.
–Turn off the water supply.
–Disconnect the waste water and fresh water connections.
–Loosen fastening screws for the furniture parts.
–If fitted, remove the base panel.
–Pull out the appliance, carefully pulling the hose behind.
25