Bosch Appliances 800, 100, 700, 600 user manual Hardware Connections, 2.2.1, Bilinx Connections

8en Analog Camera Firmware Updates via the CTFID

2.2	Hardware Connections
	This section provides a brief description of the devices necessary to connect a PC (with the
	CTFID software installed) to an analog AutoDome or to a MIC Series 550. Refer to the
	AutoDome 600 Installation Manual or the MIC Series 550 Installation Manual and to the CTFID
	User’s Manual for detailed connection information.
2.2.1	Bilinx Connections
	To create a Bilinx interface between a PC and an AutoDome 600 or MIC Series 550 you must
	have a Bosch VP-USB connector. The connector has a USB connector on one end and a female
	BNC on the other end. Figure 2.3 illustrates the interface connections:

Figure 2.3 PC to AutoDome Bilinx Connections

1	AutoDome 600 or MIC Series 550	5	BNC “T” connector
2	PC running CTFID software	6	Coax to input of monitor
3	USB Port	7	Typical CCTV monitor
4	VP-USB adapter

It is recommended that the CTFID software be installed prior to connecting the hardware to the USB port. Refer to the CTFID Installation Manual for additional information.

To see the device output, use a CCTV monitor with looping inputs or a T connector (not provided) for the coaxial cable, and plug the second coaxial cable into the CCTV monitor. Ensure that the monitor is either auto-terminating or is set to low impedance.

F.01U.097.269 4.0 2012.02 Firmware Update Manual Bosch Security Systems, Inc.