![](/images/new-backgrounds/1157349/15734933x1.webp)
5. ILLUMINATOR UNIT RE-ASSEMBLY
Make sure the input power wires are properly connected and tightened into the terminal block, all holes are sealed against moisture penetration and all mounting screws are tight.
Step 5.1 - Check the gasket attached to the rear cover plate has not been dislodged or warped.
Step 5.2 - Gently press the rear cover into place, making sure the gasket is properly seated and the photocell is centered in its viewing window. See Figure
Step 5.3 - Attach the rear cover to the housing.
Step 5.4 - Ensure the power cable has enough slack so that it is not stressed or crimped when the EX12LED unit is fixed into its final mounting position.
12