8. CAMERA AND LENS ACCESS
The following steps show the installer how to access the camera board and the camera lens.
Step 2.1 - Remove the four cap screws with a 3mm Allen key. See Figure 8-1 on page 15.
Step 2.2 - Carefully slide out the rear housing from the main enclosure. Make sure the gasket remains with the rear section. See Figure
Step 2.3 - Make any necessary camera or lens adjustments as described in Section 9, 10 or 11.
Step 2.4 - Carefully slide the rear section into the main enclosure and tighten the cap screws.
14
