Bosch Appliances HGS232UC Adjust Broil Burner Orifice, Adjust Oven Burner Orifice, Cooktop Valve

Models: HGS252UC HGS242UC HGS236UC HGS232UC HGS245UC HGS255UC HGS247UC HGS256UC HGS246UC

1 20
Download 20 pages 62.5 Kb
Page 5
Image 5
Cooktop Valve

Replace burner base, burner cap and burner grate.

Shaft

Note: Burner cap must be properly positioned on burner base for burner to light.

Figure 4

Cooktop Valve

4o Convert Cooktop Valves for Propane Use

Adjust Bypass Jets on Valves,

1.Verify that all knobs are in the "Off" position.

2.Remove knobs, springs and bezels by pulling straight out.

3.Insert flat head screwdriver into shaft and turn bypass screw clockwise until it stops turning (See Figure 4). DO NOT OVER TIGHTEN. Replace knobs, springs and bezels.

If your range is dual fuel your conversion is complete. Re- place the cover plate and warming drawer and proceed to step 9 to test your conversion.

For gas range conversions, continue to step5.

Cooktop - Left Rear

11,000

Cooktop - Riqht Rear

5,,000

Cooktop ° Left Front

7_500

Cooktop - Riqht Front

15,000

Oven - Broil (Gas Ranges Only')

14,500

Oven oBake (Gas Ranges Only)

17,000

Adjust Broil Burner Orifice

Remove oven door (see section "Removing Oven Door" in InstalJation Instructions).

Remove broil burner assembly. The broil burner assembly is attached to the top of the oven cavity, with 7 screws. Remove screws and gently pull broil burner assembly straight out being careful notre detach electrical wires. Place broil burner against back wall of oven cavity.

Adjust Orifice, The orifice is located behind the broil burner

in the back oven wall (See Figure 5). Use a 1/2"deep socket driver with 3" minimum extension to turn orifice clockwise until

it stops (2= 2 1/2 times). DO NOT OVERTIGHTEN.

Replace Broil Assembly. Replace broil assembly being careful to feed all wires through back wall of oven. Reinsert all 7 screws.

Note; The air shutter on the broil burner fits over the orifice when installed correctly.

6.Adjust Oven Burner Orifice

Tighten Orifice, The oven burner orifice is located below the air shutter (See Figure 6). Reach it through the access hole in the interior back panel of the warming drawer cavity. Use a 1/ 2" wrench to turn orifice clockwise until it stops (2 - 2 1/2 turns). DO NOT OVER TIGHTEN.

Figure 5

Oven Cavity _ Side View

Orifice

Figure 6

Oven Orifice and Air Shutter

OrificeShutter

Page 5
Image 5
Bosch Appliances HGS232UC, HGS246UC Adjust Broil Burner Orifice, Adjust Oven Burner Orifice, Oven Orifice and Air Shutter