LTC9316/00P
Instruction Manual Installation
EN
4
Access opening plates
Bolts or anchor jig
Pad
Figure 5 Placement of Pole on Pad
3.Insert the wiring into the 3" diameter hole in the base of the pole. Be sure all slack is pulled completely through.
4.Insert connecting wiring into the bottom access opening, run through the pole up to the top access opening. Insert the end rough the housing connecting hole. Close the top access opening and make necessary wiring connections at the bottom access opening (Figure 6).
Top access opening
Figure 6 Connecting Wiring Through Pole
5.Slowly lift the pole into the upright position, aligning the holes of the Base Plate with the Bolts in the concrete pad (FigurBosch Security Systems10 October 2003e 7).
Figure 7 Lifting the Pole into Position
CAUTION: Pull all slack in the wiring as you lift the pole into position to keep from pinching and possible damage.
6.Ensure that the pole is vertical on all sides. Use a bubble level or plumb bob to check.
7.Secure the pole to the pad with fasteners (Figure 8).
Nut
Lock Washer
Flat Washer
Figure 8 Securing the Pole to the Pad
4.3Mounting the AutoDome®
1.Align the holes of the AutoDome adapter plate with the holes on the mounting plate at the top of the pole (Figure 9).
Bosch Security Systems 10 October 2003
