Electrical connection
Scope of delivery
Accessories
Caution:
The dryer must be connected correctly to an A.C. contactor socket.
The mains voltage must comply with the voltage inf mation given on the identification plate (on the rear the unit).
The connected load and the necessary fusing are shown on the identification plate.
The dryer can be modified to suit the existing fusin (see page47).
Ensure that:
- the plug and the socket are compatible.
- the wire cross*section is sufficient.
-the earth system is installed in accordance with regulations.
If the mains cable needs altering, this should only b done by the after*sales service.
Do not use multiple plugs/connectors and/or exten* sion cables.
Only use current*operated circuit breakers which are marked as follows: .
Do not touch the plug with wet hands.
Always pull the plug grip to remove the plug from socket.
The dryer is delivered as a complete unit. The instr tion manual and any special equipment ordered can be found in the drum.
If required, the dryer can be adapted or added to using separately available kits (see page41 onwards).
40
