BM 2610031756 08-13_BM 2610031756 08-13 8/15/13 9:40 AM Page 7
If battery release tabs are ! WARNING cracked or otherwise damaged, do not insert into battery holster/controller. Battery can fall out during
operation.
NO
BSU
8
14
15
CONNECTING HEATING ELEmENTS
POWER CABLE
Locate the Heating Elements Power Cable inside the battery holster/controller pocket, and plug it into the battery holster/controller’s heating elements power port. With a charged battery, the Power Button and Heat Level Controller will temporarily light up, indicating the system is powered and ready to be turned on.
!WARNING Do not allow the cords to become pinched. Pinched
wires increase the risk of shock and burns.
Store the battery holster/controller into its designated pocket during usage of the jacket.
JACKET OPERATION
To turn the jacket’s heating elements on, first make sure a charged battery pack is installed.
To turn the jacket on, hold the Power Button until the LED lights up “RED.” Note that when initially turned on, the jacket will be in the “High Heat” level.
!WARNING Do not touch heating elements with bare skin.
Burns can result from improper use.
To turn the jacket off, hold the Power Button until the LED light goes off.
If the heated jacket turns off unexpectedly, check connections and charge the battery pack.
Do not use the heated ! WARNING jacket if the power button
does not turn it on and off. Any heated jacket that cannot be controlled with the power button is dangerous and must be repaired.
ADJUSTING THE HEAT LEVEL
To adjust the heat level, press the Power Button and Heat Level Controller once for each level. The following LED light colors represent the three heat levels.
RED – high heat
GREEN – medium heat
BLUE – low heat
WARNING Temperature sufficiently
!high to cause burns may occur regardless of control setting. If any discomfort occurs, shut off jacket power immediately.
USB PORT BATTERY BACKUP
OPERATION
The USB port battery backup functionality provides users with the ability to obtain extra power from their Bosch 12V max battery, in the event a cell phone, mp3 player or other battery powered device runs low on power.
! WARNING | Do not connect any device |
| that is not compatible with |
|
5VDC, 1A power source to the USB port on the battery holster/controller. Charging of
The battery holster/controller can be placed within the battery holster/controller pocket or can be attached to the user’s belt with the convenient belt clip.
To use the USB cord supplied with your personal device, plug the USB cable into the USB port and the other end into your device. To activate or
When pressed, the USB port will determine if a device is plugged in. If so, the USB port will remain on as long as the device is attached for a maximum of 2 hours. If after 60 seconds, the port does not detect a device initially connected, it will deactivate, or go to sleep, conserving battery power.
