GE GCG1520 operating instructions Adjusting the Toe Plate

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Installation Instructions.

9	Move the compactor close to its final position.
	Plug the power supply cord into a properly
	grounded receptacle.
	Carefully lift the front slightly and roll
	compactor into the cabinet opening until the
	retaining brackets stop the unit.
	Using the two #8 -18 x 1/2″ screws, fasten the
	retaining brackets to the underside of the
	countertop with the mounting screws. If the
	brackets cannot be attached to the underside	Lift here
	of countertop, attach mounting clips to
	brackets. Fasten compactor to cabinet front
	with mounting screws through mounting clips.

Retaining bracket

Mounting screw

Retaining bracket

Mounting clip

Mounting screw

Grasp sides of compactor drawer and place bottom of drawer into tracks. Lift at the handle so

10 the front of drawer will go over drawer stops. Close drawer. Check if drawer opens freely. If the toe plate rubs against floor, see section below.

Adjusting the Toe Plate

If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows:

1 Mark on each side of the toe plate the amount of toe plate that rubs the floor covering.

2 Remove the drawer from the unit. See Step 3.

3 Use a ruler and a pencil or chalk to draw a line between the marks on each side of toe plate.

4 Use scissors or utility knife to cut toe plate along line.

5 Replace drawer. See Step 10. If toe plate still rubs floor covering, repeat these steps.

14