Color Overview Camera Lens Setting | Bosch Appliances REG-D1

4.COLOR OVERVIEW CAMERA LENS SETTING

The following steps show the installer how to access the camera board and the camera lens.

Step 4.1 - Remove sunshield by loosening top bolt with a standard Philips screwdriver.

Step 4.2 - Disconnect the power source to the camera and the video signal at the BNC connector.

Step 4.3 - Remove the four cap screws with a 3mm Allen key. See Figure 4-1on page 11.

Step 4.4 - Carefully slide out the rear housing from the main enclosure. Make sure the gasket remains with the rear section.

See Figure 4-2on page 12.

Step 4.6 - Carefully slide the rear section into the main enclosure and tighten the cap screws.

- 10 -