3.0 INSTALLATION
1.Unlatch and raise the enclosure lid. The gas spring will hold the lid in place when it is fully opened.
2.Remove the camera sled from the rail:
a.Loosen the screws.
b.Slide the sled so that the screws are in the large part of the mounting slots.
c.Remove the sled.
d.Remove the parts tied to the sled.
3.TC9346A-1, -2, -3 Models Only
If you are installing the enclosure in a marine or
Refer to Figure 1 for an exploded assembly diagram of the blower assembly.
a.Disconnect the electrical plug (3) from the fan (4).
b.Remove the three sets of screws and washers (A, B, and C) that secure the fan plate (5) and fan (4) to the enclosure.
| C |
|
|
|
|
|
| 4 | D |
|
|
|
| |
5 |
|
|
|
|
A | B | C |
| B |
|
|
|
| 3 |
|
|
| B |
|
|
|
| A |
|
|
|
| TO FAN |
|
|
|
| RED | BLACK |
|
|
| 22 GA. (1 FT.) | |
|
|
| 22 GA. (1 FT.) | |
|
|
|
| |
|
|
|
| TO PC BOARD |
|
| 2 | 24 VAC MODELS | |
|
|
|
| |
1 |
|
|
|
|
Figure 1. Exploded Assembly Diagram for Blower and Circuit Board
5
