13.TC9346A-1, -2, -3 Models Only
Wire power to the enclosure to operate accessories (and the camera if its power is connected to CAM 1 on the circuit board) as follows:
a.Remove the plastic cover over the power supply section of the circuit board.
b.Connect AC high to AC HI of the
c.Connect AC neutral to AC NT of the
d.Connect ground to GND of the
e.Reinstall the plastic cover over the power supply section of the circuit board.
If the camera’s power is connected to CAM 1 on the circuit board, add the camera’s wattage to the power consumption of the accessories to determine the size of wire to use. If you are using 24 VAC, refer to Table A to determine the size of wire to use. Here are the wattages for the accessories:
Defrosters for all enclosures - 30 watts
Wipers for all enclosures - 15 watts
Blowers for 120 VAC enclosures - 15 watts
Blowers for 24 VAC enclosures - 10 watts
Blowers for 230 VAC enclosures - 15 watts
Heaters for 120 VAC enclosures - 90 watts
Heaters for 24 VAC enclosures - 50 watts
Heaters for 230 VAC enclosures - 70 watts
14.Adjust the camera focus and iris, if necessary.
15.Close the enclosure lid.
8
