Bosch Appliances VG4-100 user manual Getting Started, Camera Setup, RetentionRetenti, Front View

AutoDome Modular Camera SystemGetting Started en 3

1	Getting Started
	Install and wire the 100 Series AutoDome according to the AutoDome Modular Camera System
	Installation Manual. A typical system includes a keyboard, matrix switcher, monitor, and appro-
	priate wiring connections. Please refer to the individual product manuals for complete instal-
	lation and setup instructions for each of the system components.

2 Camera Setup

To assist setup, the VG4-100 Series camera module can be connected to a monitor through the miniature 2.5 mm monitor jack located on the camera circuit board. The monitor jack pro- vides a composite video signal with synchronization. An optional cable (part number S1460, SAP No. F01U500418) is available for making this connection.

To access the monitor jack, remove the bubble and covert liner:

1. Insert a small screw driver through the keyway in the Pendant trim-ring, rotate the dome bubble counterclockwise and remove the dome bubble. For In-Ceiling AutoDomes, you must loosen the small screw in the trim ring before rotating the bubble.

2. Press and hold the two retention buttons on each side of the camera module and then pull off the covert liner. See Figure 2.1 below.

Removing the covert liner provides access to the menu keys, and the pan and tilt thumbscrew adjustment locks. See Figure 3.1 on page 4.

RetentionRetenti

ButtonButtons(2)(2)

Menu Keyboard

Monitor Jack

Back View

Covert Liner

Front View

Fig. 2.1 100 Series Camera Module

Bosch Security Systems, Inc. VG4-100 Series User’s Manual F01U028033 1.0 2006.08