Bosch Power Tools Complete Guide to Using the Bosch Power Hammer

LOCKING

SLEEVE

FIG. 6

BM 1619P00836 12-06 1/5/07 9:43 AM Page 8

		DRILL/HAMMER DRILL SELECTION DIAL
The selector dial allows the tool to be set for				Do not use demolition or chipping bits such
various drilling/hammer drilling applications.				as bull points, chisels, spades, gouges, etc.
Rotate the selector dial right or left				Drill only action: For drilling in
depending on the below applications (Fig. 1).
!	CAUTION	Do not	operate the	woods, metals, plastics or other
		selection dial until the tool		non concrete materials.
come to a complete stop.			Shifting during
rotation of the chuck can cause damage to				Drill with hammer action: For
the tool.
				drilling in concrete, asphalt, tile or
				other similar hard materials.

		INSTALLING SDS-plus®ACCESSORIES
		Disconnect the plug from	inward until it locks automatically into place.
!	WARNING
		the power source before	Pull outward on the accessory to be certain it
making any assembly, adjustments or			is locked into the bit holder (Fig. 5).
changing accessories. Such preventive
			FIG. 5
safety measures reduce the risk of starting the
tool accidentally.
The 11258VSR Rotary Hammer utilizes			DUST SHIELD
“SDS” drill bits. The “SDS” system efficiently
transfers drilling torque and maximizes the
energy delivered per hammer blow.

Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.

Insert accessory into the tool holder through the dust shield, while twisting and pushing

REMOVING SDS-plus®ACCESSORIES

!Accessories may be hot after WARNING use. Avoid contact with skin and use proper protective gloves or cloth to

remove.

To remove an accessory, pull the locking sleeve backwards (towards the rear of tool), while pulling the accessory outward (Fig. 6).

All accessories should be wiped clean after removing.

-8-