BM 1619929713
|
| FIG. 3 |
| |
| A | BOSCH INTERNAL |
| |
| NOTCH | LOCKING STEEL |
| |
|
|
| ||
(Bosch internal |
|
| ||
locking steel) |
|
| ||
TOOL |
|
|
| |
RETAINER | SHANK END | SHANK END | ||
LEVER | 180 º | |||
|
| |||
|
|
| ||
|
| TOOL | TOOL | |
|
| HOLDER | HOLDER | |
TOOL
RETAINER
LEVER
Operating Instructions
ROCKER “ON/OFF” SWITCH
TO TURN THE TOOL "ON" depress the
TO TURN THE TOOL "OFF": depress switch to the number “0” position (Fig. 1).
For low temperatures, the machine reaches the full impact rate only after a certain time.
This
VIBRATION CONTROL HANDLE
While working, hold the tool with both hands by the handle. The handle can move upward and downward around its axis by approx. 30
mm.This has a damping effect against vibrations (Fig. 4).
For the highest possible impact damping, work only with moderate pressure.
FIG. 4
VIBRATION
CONTROL
HANDLE
"TOOL TIPS"
The tool may be switched on with either hand. Balance the tool with both hands and rest the tool on the hip.
For the best penetration rates in concrete, run the tool with a steady pressure, but do not use excessive force as this will decrease
the efficiency of the tool. Start chipping with the tool in a straight in position until the surface to be broken is chipped. Draw the hammer back at an angle of 60˚ with the surface to be broken. Apply only enough force to keep the tool weight on the accessory
