BM 3609929809 10/03 10/1/03 9:05 AM Page 8
Switch is spring loaded and will snap back automatically.
Start the tool before applying to work and let the tool come to full speed before contacting the workpiece. Lift the tool from the work before releasing the switch. DO NOT turn the switch “ON” and “OFF” while the tool is under load; this will greatly decrease the switch life.
HAND GUARD
The hand guard protects the hands while cutting, and deflects material downwards and away from the operator. The hand guard must be used at all times while using this shear.
Tool Tips
Before cutting, lightly oil the cutting line.
Hold the tool at a angle 80° to 90° to the metal surface (Fig. 2).
FIG. 2
80-90°
Excessive feed rates reduce the performance considerably and shorten the life of the cutters.
Sharp cutters produce good cutting results and protects the tool.
Do not load the tool so heavily that it stalls.
Cutting curved lines: Do not tilt the tool and work with low feed rate.
