BM 1609929C33 10/03 10/28/03 2:49 PM Page 7
Assembly
WHEEL GUARD INSTALLATION
!WARNING Use wheel guard with disc grinding wheels. Always
close the latch to secure the guard. Keep the guard between you and the wheel. Do not direct guard opening toward your body.
The position of the guard can be adjusted to accommodate the operation being performed.
To attach wheel guard DISCONNECT tool from power source.
Open guard release/lock latch and position guard on spindle neck so that the two bumps on guard, line up with the two notches on the spindle neck.
Rotate guard either direction to desired position, and close latch to secure guard in place.
TO REMOVE GUARD: Open guard release/lock latch, rotate guard until the two bumps on guard line up with the two notches on the spindle neck, and lift guard off the spindle neck.
NOTCHES
SPINDLE 
NECK 
NOTCHES
WHEEL
GUARD
GUARD BUMPS
RELEASE / LOCK
LATCH
LOCK NUT AND BACKING FLANGE
Your tool is equipped with a threaded spindle for mounting accessories. Always use the supplied lock nut (and backing flange) that has same thread size as spindle.
SIDE HANDLE
The side handle used to guide and balance the tool can be threaded into the front housing on either side of the tool, depending on per- sonal preference and comfort. Use the side handle for safe control and ease of operation.
Disc Grinding Wheel Assembly
Disconnect tool from power source. Be sure that wheel guard is in place for grinding. Place BACKING FLANGE and GRINDING WHEEL on the spindle. Thread on the lock nut and tighten nut using the supplied lock nut wrench, while holding the spindle lock in.
TO REMOVE: Reverse procedure.
SPINDLE
GRINDING
WHEEL
BACKING
FLANGE
LOCK NUT
SPINDLE
WHEEL GUARD
BACKING FLANGE
GRINDING WHEEL
LOCK NUT
