Basic Saw Operations
Detent Override
To Engage:
1.Lift the miter detent trigger 1 (Figure 24).
2.Push the detent override clip 2 forward and latch in place over edge. Release miter detent trigger 1.
3.Move miter arm 3 to any position on the miter scale.
4.Lock the miter lock knob 4 to retain miter position.
To Disengage:
5.Loosen miter lock knob 4 and lift the miter detent trigger 1 to release the detent override clip 2.
Sliding Base/Fence Extension
!WARNING Extend and use sliding base/fence when making severe bevel, severe miter or
compound cuts to provide sufficient (minimum 6”) spacing from hand to saw blade.
Sliding Base:
1.Remove hex wrench from storage position on left rear leg.
2.Loosen two (2) socket cap screws 5 in sliding base channel with the 6 mm hex wrench provided (Figure 25).
3.Extend sliding base/fence 6 to the desired position.
4.Tighten screws. Store hex wrench.
Sliding Fence:
1.Unlock the fence locking lever 7 (Figure 26).
2.Slide fence to proper position 8.
3.Relock fence in place.
! CAUTION | During transportation, sliding base and | |
fence should always be secured in the full | ||
in position. | ||
|
FIG. 24
3
FIG. 25
6
FIG. 26
8
2
4
1
50
45
40
5
7
54
