BM 2610034437
Assembly
Disconnect battery pack ! WARNING from tool before making
any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
INSERTING BITS
Move reverse switch lever to the center “OFF” position. Rotate the chuck sleeve counter- clockwise viewing from chuck end, and open chuck to approximate drill bit diameter. Insert a clean bit up to the drill bit flutes for small bits, or as far as it will go for large bits. Close chuck by rotating the chuck sleeve clockwise and securely tighten by hand (Fig. 2).
Do not use the power of the ! WARNING drill while grasping chuck
to loosen or tighten bit. Friction burn or hand injury is possible if attempting to grasp the spinning chuck.
SCREWDRIVER BIT