BM 2610034439
SANDING ACCESSORIES ASSEMBLy
BACKING PAD
!WARNING Before attaching a backing pad be sure its maximum safe
operating speed is not exceeded by the nameplate speed of the tool.
Wheel guard may not be used for most sanding operations.
Always reinstall wheel guard when converting back to grinding operations.
TO INSTALL BACKING PAD AND
SANDING DISC
Disconnect battery pack from tool.
Attach hand guard (Fig. 1). Set the tool on its top side (spindle up). Place the rubber backing pad onto the spindle shaft. Center the sanding disc on top of the backing pad. Insert the lock nut through the disc and thread onto the spindle as far as you can with your fingers. Press in the spindle lock, then tighten the backing pad securely with lock nut wrench (Fig. 5).
TO REMOVE: Reverse procedure.
FIG. 5
SPINDLE
BACKING |
PAD |
SANDING
DISC
LOCK NUT
WIRE
BRUSH
WIRE BRUSH ASSEMBLy
Before assembling wire brush to this tool, disconnect from the power source. Attach hand guard (Fig. 1). Wire brushes are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLy
Before assembling wire wheel to this tool, disconnect from the power source. Attach type 27 guard (Fig. 2). Wire wheeels are equipped with their own threaded hub, simply thread on to spindle. Be sure to seat against shoulder before turning tool “ON”.
TO REMOVE: Reverse procedure.
MASONRy CUTTING WHEEL ASSEMBLy Disconnect battery pack from tool. Completely unscrew the four screws and rotate the tool head carefully to the new position without removing it from the housing. For paddle switch tools, switch should face “down” towards work surface. For slide switch tools, slide should face “up” towards user, so the tool can be used for long masonry cutting applications. Screw in and tighten the four screws again. (Fig. 6)
!WARNING Return tool head to original position when returning to
grinding, sanding, brushing or metal cutting applications.
Install dust extraction guard with foot plate for masonry cutting applications so that the
FIG. 6
rotation of the wheel will be towards the vacuum extraction port. Place BACKING FLANGE and DRY DIAMOND WHEEL on the spindle. Thread on the LOCK NUT and tighten nut using the supplied lock nut wrench, while holding the spindle lock in. (Fig. 7)
