BM 1619929426 8/01 8/2/01 1:19 PM Page 10
REMOVING ACCESSORIES
! | WARNING | When removing the bit from | |
the tool avoid contact with | |||
|
|
skin and use proper protective gloves when grasping the bit or accessory. Accessories may be hot after prolonged use.
To remove an accessory, pull the locking sleeve backwards (towards the rear of tool), while pulling the accessory outward. All accessories should be wiped clean after removing.
RELEASING AND INSERTING BATTERY PACK
Set Forward/Reversing lever to the center (off position). Before inserting the battery pack, remove the protective cap if necessary. Slide charged battery pack into the handle until the battery pack locks into position.
To remove the battery pack, press back the unlocking button and pull the battery pack downward.
PROTECTIVE
CAP
BATTERY PACK
LOCKING BUTTON
CHARGING BATTERY PACK
Plug charger cord into your standard power outlet, then insert battery pack into charger.The charger’s green indicator light will begin to “BLINK”. This indicates that the battery is receiving a fast charge. Fast- charging will automatically stop when the battery pack is fully charged.
When the indicator light stops “BLINKING” (and becomes a steady green light) fast charging is complete, and an acoustical signal sounds for a period of approximately 2 seconds which indicates that the battery is completely charged.
The battery pack may be used even though the light may still be blinking. The light may
require more time to stop blinking depending on temperature.
The purpose of the green light is to indicate that the battery pack is
When charging several batteries in sequence, the charge time may slightly increase.
When the battery pack is fully charged, unplug the charger (unless you're charging another battery pack) and slip the battery pack back into the tool.
