BM 1619929426 8/01 8/2/01 1:19 PM Page 9
DRILL/HAMMER DRILL SELECTION DIAL
The selector dial allows the tool to be set for various drilling applications. Shift the dial right or left depending on the below applications.
!CAUTION Do not operate the selection dial until the tool
come to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.
Do not use demolition or chipping bits such as bull points, chisels, spades, gouges, etc.
Drill only action: For drilling in woods, metals, plastics or other non concrete materials.
Drill with hammer action: For drilling in concrete, asphalt, tile or other similar hard materials.
BATTERY CHARGED CONDITION INDICATOR
The battery is equipped with a charged condition indicator. This indicator shows the charged condition of the battery during the working process.
BUTTON
By pressing the button ON, the charged condition can also be checked when the battery is removed or when the machine is not in use. After approx. 4 seconds, the charged indicator switches off automatically.
When the last indicating element blinks (0 - 10%), the battery is nearly discharged and must be recharged.
To maintain the indicator accuracy, occasionally discharge the battery until the speed of the machine is distinctly reduced and the charged condition indicator goes off completely.
Charged Condition
0 - 10% (Battery discharged)
10 - 20%
20 - 40%
40 - 60%
60 - 80%
80 - 100% (Battery charged)
INSTALLING ACCESSORIES
Disconnect battery pack from tool or place the switch in the locked or off position before
making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant.
Insert accessory into the tool holder through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the tool holder.
NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The “cost” to maintain sharp and undamaged accessories is more than offset by the “time saved” in operating the tool with sharp accessories.
