BM 1619929426 8/01 8/2/01 1:19 PM Page 8
Operating Instructions
VARIABLE SPEED CONTROLLED TRIGGER SWITCH
Your tool is equipped with a variable speed trigger switch. The tool speed can be controlled from the minimum to the maximum nameplate RPM by the pressure you apply to the trigger. Apply more pressure to increase the speed and release
pressure to decrease speed. This accurate speed control enables you to drill without center punching. It also permits you to use as a power screwdriver. Bits are available for driving screws as well as running bolts and nuts.
FORWARD/REVERSING LEVER & TRIGGER LOCK
Your tool is equipped with a forward/ reversing lever and trigger lock located above the trigger (Fig. 1). This lever was designed for changing rotation of the chuck, and for locking the trigger in an “OFF” position to help prevent accidental starts and accidental battery discharge. For forward rotation, (with chuck pointed away from you) move the lever to the far left. For
reverse rotation move the lever to the far right. To activate trigger lock move lever to the center off position.
! | CAUTION | Do not change direction of | |
rotation until the tool comes | |||
|
|
to a complete stop. Shifting during rotation of the chuck can cause damage to the tool.
SLIP CLUTCH
The tool has an internal preset clutch. The clutch is set such that sufficient force is transmitted to the bit for most drilling conditions but it will slip when bit binds in the hole or the tool is overloaded. Be aware that due to required clutch setting, you may experience a torque reaction an instant before the clutch slips. This torque reaction will twist the body of the rotohammer in the opposite direction as the bit rotates, i.e.,
counterclockwise. As clutch is slipping, the bit will most likely stop rotating. When the binding force on the bit is removed the clutch automatically resets. If you experience bit binding and clutch begins to slip, immediately turn the tool "OFF" and correct the condition leading to the bit binding.
AUXILIARY HANDLE
The tool should be supported with the auxiliary handle, which can be swiveled 360˚. To swivel the handle loosen the hand grip, move the handle to desired position, and securely retighten the hand grip.
DEPTH GAUGE
Your drilling depth can be
Setting depth: After the auxiliary handle is installed, slide the depth gauge to desired depth and securely tighten wing knob.
BRAKE
When the trigger is released it activates the electrical brake to stop the chuck quickly. This is especially useful in the repetitive driving and removal of screws.
