Carrier 48TJF008-012, 48TJE008-014, 48TJD008-014 Ð Burner Section Details, Ð Burner Tray Details

Models: 48TJF008-012 48TJD008-014 48TJE008-014

1 40
Download 40 pages 31.89 Kb
Page 29
Image 29
Fig. 45 Ð Burner Section Details

REMOVAL AND REPLACEMENT OF GAS TRAIN (Fig. 45 and 46)

1.Shut off manual gas valve.

2.Shut off power to unit.

3.Slide out burner section side panel (not shown).

4.Disconnect gas piping at unit gas valve.

5.Remove wires connected to gas valve. Mark each wire.

6.Remove wires from ignitor and sensor wires at the Inte- grated Gas Unit Controller (IGC).

7.Remove the 2 screws that attach the burner rack to the vestibule plate.

8.Slide the burner tray out of the unit (Fig. 46).

9.To reinstall, reverse the procedure outlined above.

CLEANING AND ADJUSTMENT

1.Remove burner rack from unit as described in Removal and Replacement of Gas Train section, above.

2.Inspect burners; if dirty, remove burners from rack.

3.Using a soft brush, clean burners and cross-over port as required.

4.Adjust spark gap. See Fig. 47.

5.Reinstall burners on rack.

6.Reinstall burner rack as described in Removal and Re- placement of Gas Train section, this page.

Replacement Parts Ð A complete list of replace- ment parts may be obtained from any Carrier distributor upon request.

ROLLOUT

SWITCH

BURNER

SECTION

FLUE

EXHAUST

VESTIBULE

PLATE

INDUCED-DRAFT

MOTOR

MANIFOLD

PRESSURE TAP

Fig. 46 Ð Burner Tray Details GAS VALVE

Fig. 45 Ð Burner Section Details

Fig. 46 Ð Burner Tray Details

29

Page 29
Image 29
Carrier 48TJF008-012, 48TJE008-014, 48TJD008-014 installation instructions Ð Burner Section Details, Ð Burner Tray Details