Carrier 48TJF008-012 Ð Damper Panel with Manual, Outdoor-AirDamper Installed, in Typical Unit

Step 8 Ð Adjust Factory-Installed Options

APOLLO CONTROL Ð The optional Apollo control is used to actively monitor all modes of operation as well as indoor (evaporator) fan status, ®lter status, and indoor-air quality. The Apollo control is designed to work with Carrier TEMP and VVT systems.

The thermostat must be wired to the Apollo control before starting the unit. Refer to the Apollo control installation in- structions for information on installing the thermostat. See Fig. 13 for Apollo location.

MANUAL OUTDOOR-AIR DAMPER Ð The outdoor-air hood and screen are attached to the basepan at the bottom of the unit for shipping.

Assembly:

1.Determine quantity of ventilation required for building. Record amount for use in Step 8.

2.Remove ®lter access panel by raising panel and swing- ing panel outward. Panel is now disengaged from track and can be removed. No tools are required to remove the ®lter access panel. Remove outdoor-air opening panel. Save panels and screws. See Fig. 14.

3.Separate hood and screen from basepan by removing the screws and brackets securing them. Save all screws and discard brackets.

4.Replace outdoor air opening panel with screws saved from Step 2.

5.Place hood on front of outdoor-air opening panel. See Fig. 15 for hood details. Secure top of hood with the 6 screws removed in Step 3. See Fig. 16.

6.Remove and save 8 screws (4 on each side) from sides of the manual outdoor-air damper.

7.Align screw holes on hood with screw holes on side of manual outdoor-air damper. See Fig. 15 and 16. Secure hood with 8 screws from Step 6.

8.Adjust minimum position setting of the damper blade by adjusting the manual outdoor-air adjustment screws on the front of the damper blade. See Fig. 14. Slide blade vertically until it is in the appropriate position deter- mined by Fig. 17. Tighten screws.

WIRING TO	APOLLO	CONTROL
THERMOSTAT	CONTROL	WIRING

OUTDOOR

AIR OPENING

PANEL

Fig. 14 Ð Damper Panel with Manual

Outdoor-Air Damper Installed

Fig. 15 Ð Outdoor-Air Hood Details

HOOD

NOT

SHOWN)

Fig. 13 Ð Apollo Control Factory-Installed	Fig. 16 Ð Damper with Hood Attached
in Typical Unit

11