Cisco Systems SCE8000

9-25

Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7

OL-16478-02

Chapter 9 Removal and Replacement Procedures

Removing and Replacing the Optical Bypass Module

Step 3 To remove the SPA from the SIP, unfasten the captive installation screws on the SPA.

Step 4 Grasp the handles of the SPA and pull the SPA from the SIP.

Removing and Replacing the Optical Bypass Module

• Removing the Optical Bypass Module, page 9-25

• Installing the Optical Bypass Module, page 9-25

• Replacing the Optical Bypass Module without Disrupting Traffic on the Link , page 9-26

Removing the Optical Bypass Module

Step 1 Disconnect all cables.

Step 2 Loosen the two captive screws on the module.

Step 3 Pull the module out of the slot. Place your other hand under the m odule to support the weight of the

module. Do not touch the module circuitry.

Step 4 Place the module on antistatic foam, or immediately reinstall it in another slot.

Step 5 If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain

proper airflow through the chassis.

Installing the Optical Bypass Module

Step 1 Remove the module filler plate by loosening the two screws.

Step 2 Insert the module into the opening in the panel. There are no guide rails. Do not touch the module

circuitry.

Step 3 Tighten the two captive screws on the module.

Step 4 Connect the cables as described in Cabling the 10GBE Line Interface Ports: Using the External Optical

Bypass Module, page 6-11.