9-16
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-02
Chapter 9 Removal and Replacement Procedures
Removing and Replacing Modules
Step 8 Carefully slide the module into the slot until the EMI gasket along the top edge of the module makes
contact with the module in the slot above it and both ejector levers have closed to approximately 45
degrees with respect to the module faceplate. (See Figure 9-12.)
Figure 9-12 Clearing the EMI Gasket
Step 9 Using the thumb and forefinger of each hand, grasp the two ejector levers and press down to create a
small (0.040 inch [1 mm]) gap between the module EMI gasket and the module above it. (See
Figure 9-12.)
Note Do not press down too forcefully on the ejector levers. They will bend and be damaged.
270908
FAN STATUS
SCM 1
SCM 2
SIP 3
4
SCE8000-FAN
SYSTEM POWER
OPTICAL BYPASS
STATUS
AUXPORT2
LINK
ACTIVE
MASTER
SCE8000 EXTENDED SERVICE CONTROL MODULE
OPTICAL
BYPASS
OPTICAL
BYPASS
CONSOLE
10 100
1000
LINK
ACTIVE
PORT1
A C
A B
C D
B D
STATUS
CTRL
OPB-SCE8K-MM
OPTICAL BYPASS1
TX
RX
TX
RX
TX
RX
TX
RX
A C
A B
C D
B D
STATUS
CTRL
OPB-SCE8K-MM
OPTICAL BYPASS2
TX
RX
TX
RX
TX
RX
TX
RX
SYSTEM POWER
OPTICAL BYPASS
STATUS
AUX PORT2
10 100
1000
LINK
ACTIVE
MASTER
SCE8000 EXTENDED SERVICE CONTROL MODULE
SCE8000-SCM-E
SCE8000-SCM-E
SCE8000-SIP
CONSOLE
10 100
1000
LINK
ACTIVE
PORT1
OPTICAL
BYPASS
OPTICAL
BYPASS
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
10 100
1000
1mm Gap between the module
EMI gasket and the
module above it.
Press down
Press down