C H A P T E R 6
Cabling the Line Ports and Completing the
Installation
This chapter provides instructions for cabling the Cisco SCE8000 10 Gigabit Ethernet ports for single, cascaded, and MGSCP topologies. In a cascade topology, this includes the cascade ports as well as the line ports.
The 10 Gigabit Ethernet ports are located on the 10G SPA modules, which are installed in the
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures outlined in the section Cascaded Systems, page
Note When installing an External Optical Bypass module, the Cisco SCE8000 line ports are connected to the module. See Cabling the 10GBE Line Interface Ports: Using the External Optical Bypass Module, page
•Connecting the Line Ports to the Network, page
•The Optical Bypass Module, page
•Cabling the 10GBE Line Interface Ports, page
•How to Load and Activate a Service Control Application, page
•Cascaded Systems, page
Connecting the Line Ports to the Network
•Single Link: Inline Topology, page
•Single Link:
•Dual Link: Single Cisco SCE8000 Topologies, page
•Dual Link: Two Cisco SCE8000s Topology, page
•
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
|
| ||
|
|