9-12
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-02
Chapter 9 Removal and Replacement Procedures
Removing and Replacing Modules
• Listen for the fans; you should immediately hear them operati ng. If you do not hear them, ensure
that the fan assembly is inserted completely in the chassis and the faceplate is flush with the switch
back panel.
• Verify that the FAN STATUS LED is green. If the LED is red, one or more fans is faulty.
Removing and Replacing Modules
The Cisco SCE8000 platform supports two types of modules:
• Service Control Module (SCE8000-SCM-E)
• SPA Interface Processor (SCE8000-SIP)
The following diagram shows the position of these modules in the Cisco SCE8000 c hassis.
Figure 9-8 Slot Numbers on Cisco SCE8000 Chassis
Required Tools
These tools are required to remove or install modules in the Cisco SCE800 0 chassis:
• 3/16-inch flat-blade screwdriver
• Number 2 Phillips screwdriver
• Wrist strap or other grounding device
• Antistatic container that the module was shipped in
FAN STATUS
SCM
1
SCM
2
SIP
3
4
SCE8000-FAN
SYSTEM POWER
OPTICAL BYP
ASS
STATUS
AUXPORT2
LINK
ACTIVE
MASTER
SCE8000 EXTENDED SERVICE CONTROL MODULE
OPTICAL
BYPASS
OPTICAL
BYPASS
CONSOLE
10 100
1000
LINK
ACTIVE
PORT1
A C
A B
C D
B D
STATUS
CTRL
OPB-SCE8K-MM
OPTICAL BYPASS1
TX
RX
TX
RX
TX
RX
TX
RX
A C
A B
C D
B D
STATUS
CTRL
OPB-SCE8K-MM
OPTICAL BYPASS2
TX
RX
TX
RX
TX
RX
TX
RX
SYSTEM POWER
OPTICAL BYPASS
STATUS
AUXPORT2
10 100
1000
LINK
ACTIVE
MASTER
SCE8000 EXTENDED SERVICE CONTROL MODULE
SCE8000-SCM-E
SCE8000-SCM-E
SCE8000-SIP
CONSOLE
10 100
1000
LINK
ACTIVE
PORT1
OPTICAL
BYPASS
OPTICAL
BYPASS
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
STATUS
ACTIVE/LINK
SPA-1X10GE-L-V2
10 100
1000
270889
Slots 1-4
(top to bottom)
SCE8000-
SCMs
SCE8000-
SIP
Optional
Optical Bypass
Modules