Cisco Systems SCE8000 - page 136

9-14
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
OL-16478-02
Chapter 9 Removal and Replacement Procedures
Removing and Replacing Modules
Note If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent
modules toward the open slot, reducing the opening size and making it difficult to install the re placement
module.
Step 5 Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. To
remove a module, follow the procedure in Removing a Module, page 9-17
Step 6 Fully open both ejector levers on the new module. (See Figure 9-10.)
Figure 9-10 Ejector Levers and Captive Installation Screws
SCE8000 EXTENDED SERVICE CONTROL MODULE
SCE8000-SCM-E
STATUS
OPTICAL BYPASS
MASTER
SYSTEM POWER
10/100/
1000
LINK/
ACTIVE
OPTICAL
BYPASS1 CONSOLE PORT1
10/100/
1000
LINK/
ACTIVE
OPTICAL
BYPASS2 AUX PORT2
270901
Ejector lever
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
Captive
installation
screws