Paradyne 6800 manual Preinstallation Steps for the Analysis NMS Package

COMSPHERE 6800 Series Network Management System

Preinstallation Steps for the ANALYSIS NMS Package

To configure the IPC-900, refer to Figure 2-5 and follow the instructions below.

1.Set the DIP switch labeled SW1 to the I/O address 2B0.

2.Set the DIP switch labeled SW2 to the memory address D2000.

3.Set the IRQ jumper to IRQ 5.

4.Follow the instructions under Optional Host Upgrade Procedures to install the IPC-900 card in Slot 2.

5.When you have installed all cards in the processor, you must run the EISA Configuration Utility (ECU) to configure the System 5000's resources to match all circuit cards in the system. For instructions on how to run the ECU, refer to the section, EISA Configuration Utility.

6.You must load the ANALYSIS Gateway software as described in Chapter 5, Loading and Restoring Software.

IRQ

5

147

SW1 SW2

ON OFF

		Input/Output								Controller Memory								Interrupt Request (IRQ)
Starting Address										Starting Address								Level Jumper
	Switch (SW1)										Switch (SW2)							Set to 5
1		2	3	4	5	6	7	8	ON	1 2		3	4	5	6	7	8
									OFF
				2B0								D2000						491-11591a-01
									Push Switch

to the Indicated Position:

Figure 2-5. IPC-900 Ð Switch and Jumper Locations

2-10 January 1997 6800-A2-GN22-30