Paradyne 6800 Optional Host Upgrade Procedures, Preinstallation Checks for the Token Ring Card

COMSPHERE 6800 Series Network Management System

4.When you have installed all cards in the processor, you must run the EISA Configuration Utility to configure the System 5000's resources to match the requirements of this circuit card. For instructions, refer to the section, EISA Configuration Utility.

Preinstallation Checks for the Token Ring Card

The Proteon P1990plus Network Interface Card requires no jumper or switch settings on the card. All settings are configured using the EISA Configuration Utility.

Optional Host Upgrade Procedures

Once you have obtained the appropriate field upgrade package and configured the cards, you are ready to install the circuit cards in the host processor. The following sections explain how to do this.

Installing the Third Hard Drive in the System 5000

To physically install the third hard disk drive in the System 5000 chassis (refer to Figure 2-8), perform the following steps:

1.Attach the 3.5I mounting brackets to the side of the disk drive.

2.Slide the drive into the chassis and attach the 50-pin SCSI bus cable using the next connector available on the cable.

3.Attach the 5-pin power connector to the disk drive.

4.Insert the screws through the mounting bracket into the front of the chassis. Secure the drive in the chassis.

2-14 January 1997 6800-A2-GN22-30