Paradyne 6800 manual Connecting the Host Processor to the Bytex UMS

COMSPHERE 6800 Series Network Management System

Bytex UMS

This section explains how to connect the Bytex UMS to the NMS host processor or the User Interface Processor (UIP). The UIP connection is restricted to cut-through only.

To connect the Bytex Switch to the host processor or UIP, you will need the following materials:

•035-0153-0031 10-pin modular to 10-pin modular cable

•002-0039-0031 ACU/MODEM adapter

Figure 4-28 illustrates the connection for both the host processor and UIP to the Bytex UMS for either the Bytex alerts or cut-through.

Connecting the Host Processor to the Bytex UMS

To connect a host processor to the Bytex UMS, perform the following steps:

1.Connect the grounded end of the 035-0153-0031 cable to a port on the IPC-1600 card.

2.Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 ACU/MODEM adapter.

3.Connect the 002-0039-0031 ACU/MODEM adapter to a port on the Bytex UMS.

Figure 4-28. Bytex UMS Connection

4-56 January 1997 6800-A2-GN22-30