Paradyne 6800 manual Preinstallation Steps for the 16 Control Channel Package

Preparing the Processors

Preinstallation Steps for the 16 Control Channel Package

To prepare the DCP/MUXi card for installation in the System 5000 host processor, refer to

Figure 2-7 and perform the following steps:

EE39

46

E	E
	3
47
	8
E48	E37	E33
		E32
E 44 E45		E31

E43

E42

E3

	E1	E
		4
E2
		1

E40

E36	E
	30
E	E
3	29
5	E28
E34

SW1

494-14511-01

Figure 2-7. DCP/MUXi Card

1.Remove two jumpers on the card, one at position E32-E33 (interrupt request) and the other at position E37-E38 (transparent mode interrupt). You may store a jumper for future use, such as running diagnostics, by placing it on one pin only.

2.Verify that all other jumpers on the card are in the factory default positions.

3.Verify that the I/O address is set on the card at block SW1 as shown in Table 2-2.

Table 2-2

DCP/MUXi Ð I/O Address Switch Settings

SWI Description	1	2	3	4
DCP/MUXi Control Channels 9Ð16	on	on	on	off

6800-A2-GN22-30 January 1997 2-13