Shindaiwa 89304, C3410/EVC manual Handlebar C unit, Prior to Assembly, Install the handlebar

Assembly

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

IMPORTANT!

The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as viewed by the operator during normal operation.

Handlebar C unit

This unit comes fully assembled with the exception of the cutting attachment shield and cutting attachment.

Prior to Assembly

Before assembling, make sure you have all the components required for a complete unit and inspect unit and components for any damage.

ŶHandlebar and Throttle assembly

ŶEngine and shaft assembly

ŶCutting attachment shield

ŶCutting attachment

ŶKit containing cutting attachment shield, mounting bracket and hardware, this owner’s/operator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a spark plug/screwdriver combination wrench, and a scraper.

Install the handlebar:

1.Use the 4 mm hex wrench to remove the lower cap retaining screws from the handlebar bracket. Remove the cap from the bracket, and note the position of the two spacers installed between the bracket halves.

2.Position the handle on the outer tube for- ward of Handle Positioning Label as shown. Reassemble the lower cap to the handlebar bracket in the reverse order of disassembly.

3.Locate the handle in the best position for operator comfort.

4.Firmly tighten both lower cap retaining screws.

5.Secure the cable to the outer pipe with the 2 bands as the illustration shows. The 2 bands are in the tool bag.

Ignition switch
Throttle
trigger	Handlebar
Handle positioning	Hanger
label
Outer tube
Lower cap	Spacers
retaining
screws	Bands
Mounting the brushcutter handlebar

6