Paradyne 6800 manual Hardware Configuration Menu Installing Unix on Host Computer

Loading and Restoring Software

Please specify Hardware Configuration:

1.Hardware configuration I (Single hard disk - UIP)

2.Hardware configuration II (Two or more hard disks - NMS HOST)

3.Exit Installation

Please enter your choice [1-3]:

494-13956-02

Figure 5-4. Hardware Configuration Menu (Installing UNIX on Host Computer)

6.To proceed, TYPE: 1 PRESS: Enter

The menu in Figure 5-4 appears (on a 5000 platform, Item 2. reads as follows: Hardware Configuration II (two hard disks Ð NMS Host):

7.For the host computer, TYPE: 2

PRESS: Enter

If you are loading an Altos System 15000, the system prompts:

Enter the SCSI Host Adapter number of the hard disk [0±1] or type \`q' to quit: TYPE: 0

PRESS: Enter

On both 5000 and 15000 platforms, the system sets the operating system environment, configures the hard disk, creates a UNIX partition, and divides the partition into file systems and swap space. These processes take about fifteen minutes.

When this is complete, the following message appears:

Altos UNIX System V Operating System Serialization

When prompted, use the seral number and activation key included with the Altos System V Operating System distribution

Enter your serial number or enter q to quit:

TYPE: the UNIX serial number (found on the Serial Number card attached to the Release Notes)

PRESS: Enter

6800-A2-GN22-30 January 1997 5-9