Paradyne 6800 manual NAU Memory Jumper Locations and Settings

Preparing the Processors

NOTE

Before optioning the NAU, check the faceplate to determine if this version of the NAU has a Link Integrity Function Switch. If it does, move the switch to the enabled position. If the StarLAN NAU does not have a Link Integrity Function Switch, you must replace the NAU with an EtherLink II card. For more information, refer to the StarLAN 10 Network PC NAU Installation Guide.

Figure 2-29 shows the jumper locations and settings for the NAU. To implement the setting and install the StarLAN 10 PC NAU, perform the following steps:

1.Use the default IRQ setting of 2 (J12).

2.Use the default I/O address setting of 360Ð367 (J3).

3.Set the RAM address to C8000ÐC8FFF, Pins 2 & 3 (J6).

4.Set the RAM size to 16 kb (J5).

5.Insert the card into Slot 3.

6.Insert the appropriately configured StarLAN 10 NAU into Slot 3 and secure with the chassis screw.

7.Insert the Paradise Windows Accelerator video card in the first available slot and secure with a chassis screw. Confirm that all SW1 switches are in the OFF position.

8.Close the 6386/25 computer cover and reconnect monitor and keyboard cables.

9.Insert the Customer Test disk that comes with the 6386/25. This disk will be used to reformat the hard disk.

10.Start the 6386/25 and the computer will boot from the Customer Test disk. The Customer Diagnostics introduction screen is displayed.

PRESS: Enter

J1	J5	J13
SPARES
J14		P2	J3

J6

J11 J12

491-11704a

Figure 2-29. NAU Memory Jumper Locations and Settings

6800-A2-GN22-30 January 1997 2-55