Paradyne 6800 manual Connecting a Local AT&T 6286 or, Connecting a Remote AT&T 6286 or

Connecting the Components

Connecting a Local AT&T 6286 or 6386

To connect an AT&T 6286 or 6386 as a local basic-feature workstation, perform the following steps:

1.Connect the grounded end of the 035-0153-0031 cable to one of the following ports on either the host processor or the UIP:

±COM1/COM2 port: use the 002-0054-0031 connector

±IPC-1600: connect directly to port

2.Connect the other end of the 035-0153-0031 cable to the 002-0052-0031 connector.

3.Connect the 002-0052-0031 connector to the 25-pin serial connector on the basic-feature workstation.

Connecting a Remote Altos 486DX/33, an Altos SX/20, or an AT&T 6386 SX/EL

To connect an Altos 486DX/33, an Altos SX/20, or an AT&T 6386 SX/EL at a remote location, you will need two DCE devices with the following characteristics:

•Asynchronous

•Full-duplex

•Flow control ON

•Bit rates of 1200, 2400, 4800 or 9600 bps

To establish the connection, perform the following steps at the processor end:

1.At the host processor or UIP end, connect the grounded end of a 035-0153-0031 cable to an available port on the IPC-1600 card. If connecting to a COM port, use the 002-0054-0031 connector.

2.Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.

3.Connect the 002-0039-0031 connector to the local DCE device.

4.At the remote end, connect one end of the 035-0149-2531 cable to the remote DCE device.

5.Connect the other end of the 035-0149-2531 cable to the workstation 25-pin serial connector on the basic-feature workstation.

Connecting a Remote AT&T 6286 or 6386

To connect an AT&T 6286 or 6386 at a remote location, you will need two DCE devices with the following characteristics:

•Asynchronous

•Full-duplex

•Flow control ON

•Bit rates of 1200, 2400, 4800 or 9600 bps

6800-A2-GN22-30 January 1997 4-17