Paradyne 6800 manual Connecting Remotely

COMSPHERE 6800 Series Network Management System

2.Depending on the application, connect the other end of the 035-0153-0031 cable to the 002-0040-0031 (male) or 002-0052-0031 (female) connector.

3.Connect the 002-0040-0031 or 002-0052-0031 connector to the terminal port of the computer system requiring VT100 terminal emulation.

Connecting Remotely

To connect a remote computer system requiring VT100 terminal emulation, you will need the following materials:

•035-0153-0031 cable

•002-0039-0031 connector

•Two DCE devices with the following characteristics:

ÐAsynchronous

ÐFull-duplex

ÐFlow control ON

ÐBit rates of 1200, 2400, 4800, 9600, 19,200 bps

•835-5783-0011 cable (depending upon the computer system you are connecting to, you may need an 835-3564-2511 cable, which is male to female, instead of the 835-5783-0011 cable, which is male to male)

To establish the connection, perform the following steps at the processor end:

1.Connect the grounded end of the 035-0153-0031 cable to an available port on the IPC-1600 card in the host processor or UIP.

2.Connect the other end of the 035-0153-0031 cable to the 002-0039-0031 connector.

3.Connect the 002-0039-0031 connector to the local DCE.

Perform the following steps at the remote end:

1.Connect the male end of the 835-5783-0011 or the 835-3564-2511 cable to the remote DCE.

2.Connect the male end of the 835-5783-0011 or the female end of the 835-3564-2511 cable to the terminal port of the computer system requiring VT100 terminal emulation.

4-42 January 1997 6800-A2-GN22-30