Paradyne 6800 manual Full-Feature Workstation, Preinstallation Checks for the EtherLink II Card

Preparing the Processors

Full-Feature Workstation

Preinstallation Checks for the EtherLink II Card

The 3COM EtherLink II Card is installed at the factory for workstations from Paradyne but the user should check that the settings on the card are properly configured.

1.Check the jumper settings on the EtherLink II card (see Figure 2-27). Confirm that:

a.The I/O Base Address jumper at J3 is set to 300.

b.The Memory Address jumper at J3 is set to C8000.

c.The Data Mode jumper at J5 is set to 16 bit transmission.

2.Be sure that the EtherLink II card is properly seated.

		300
		310
		330	BASE
		350
		250
			I/O
		280
		2A0
		2E0
		DISABLE	J3
			MEMORY
		C8000
		CC000
		D8000
		DC000
			493-14256
	J5	MODE
16
8		DATA

Figure 2-27. EtherLink II Card Jumper Settings

6800-A2-GN22-30 January 1997 2-51