Dell T710 owner manual 105, Installing and Removing a Memory Module Memory module

Figure 3-11. Installing and Removing a Memory Module

1

2

3

1	memory module	2 memory module socket levers (2)
3	alignment key

7Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in the socket.

NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way.

8Press down on the memory module with your thumbs until the socket levers latch into a locked position.

When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on the other sockets that have memory modules installed.

9Repeat step 5 through step 8 of this procedure to install the remaining memory modules. See Table 3-1 or Table 3-2.

10Install the cooling shroud. See "Installing the Cooling Shroud" on page 88.

11Close the system. See "Closing the System" on page 86.

12Place the system upright and on its feet on a flat, stable surface.

13Rotate the system feet outward.

Installing System Components

105