Dell T710 Configuration on, Each CPU should, Match, Embedded NICx, NICy, Management, Shared NIC=

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
DIMM	Invalid memory	Ensure that the memory
configuration on	configuration on a dual-	modules are installed in a
each CPU should	processor system. The	valid configuration. See
match.	memory module	"General Memory Module
	configuration for each	Installation Guidelines" on
	processor must be identical.	page 98.
Embedded NICx and	The OS NIC interface is set	Check the system
NICy:	in BIOS. The Management	management software or the
OS NIC=<ENABLED	Shared NIC interface is set in	System Setup program for
DISABLED>,	management tools.	NIC settings. See
Management		"Troubleshooting a NIC" on
Shared NIC=		page 161.
<ENABLED
DISABLED>
Error 8602 -	Mouse or keyboard cable is	Reseat the mouse or
Auxiliary Device	loose or improperly	keyboard cable.
Failure. Verify	connected.
that mouse and	Defective mouse or keyboard. Ensure that the mouse or
keyboard are
		keyboard is operational. See
securely
		"Troubleshooting a USB
attached to
		Device" on page 160.
correct
connectors.
Gate A20 failure	Faulty keyboard controller;	See "Getting Help" on
	faulty system board.	page 193.
Invalid	An invalid system	Run the System Setup
configuration	configuration caused a	program and review the
information -	system halt.	current settings. See "Using
please run SETUP		the System Setup Program
program.		and UEFI Boot Manager" on
		page 57.

Invalid PCIe card	The system halted because
found in the	an invalid PCIe expansion
Internal_Storage	card is installed in the
slot!	dedicated storage controller
	slot.

Remove the PCIe expansion card and install the integrated storage controller in the dedicated slot.

44

About Your System