Internal SD Module

Installing the Internal SD Module

WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.

2Rotate the system feet inward and lay the system on a flat surface.

3Open the system. See "Opening the System" on page 85.

4Position the module so the tabs on the underside of the tray fit into the hooks on the chassis, then lower the opposite edge of the card into place. See Figure 3-18.

Installing System Components

119

Page 119
Image 119
Dell T710 owner manual Installing the Internal SD Module, 119