Dell T710 E1410 Internal Error, Detected, E1414 CPU # temp, CPU heatsink, E1418 CPU # not, Seated

Table 1-1. LCD Status Messages (continued)

Code	Text	Causes	Corrective Actions
E1410	Internal Error	Specified processor has an	Remove AC power to the
	detected.	internal error. The error	system for 10 seconds and
	Check "FRU X". may or may not have been		restart the system.
		caused by the processor.	If the problem persists,
			see "Getting Help" on
			page 193.
E1414	CPU # temp	Specified processor is out	Ensure that the processor
	exceeding	of acceptable temperature	heat sinks are properly
	range. Check	range.	installed. See
	CPU heatsink.		"Troubleshooting the
			Processors" on page 179
			and "Troubleshooting
			System Cooling
			Problems" on page 166.
E1418	CPU # not	Specified processor is	Ensure that the specified
	detected.	missing or bad, and the	microprocessor is
	Check CPU is	system is in an	properly installed. See
	seated	unsupported	"Troubleshooting the
	properly.	configuration.	Processors" on page 179.
E141C	Unsupported	Processors are in an	Ensure that your
	CPU	unsupported	processors match and
	configuration. configuration.		conform to the type
	Check CPU or		described in the processor
	BIOS revision.		technical specifications
			outlined in your system’s
			Getting Started Guide.

E141F CPU # protocol	The system BIOS has
error. Power	reported a processor
cycle AC.	protocol error.

Remove AC power to the system for 10 seconds and restart the system.

If the problem persists, see "Getting Help" on page 193.

28

About Your System