Dell T710 Alert! Power, Required exceeds, PSU wattage, System boot, Alert! Redundant, Fatal error

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
Alert! Power	The system configuration of	If any system components
required exceeds	processor(s), memory	were just upgraded, return
PSU wattage.	modules, and expansion	the system to the previous
Check PSU and	cards may not be supported	configuration. If the system
system	by the power supplies.	boots without this warning,
configuration.		then the replaced
Alert!		component(s) are not
		supported with this power
Continuing
		supply. If Energy Smart
system boot
		power supplies are installed,
accepts the risk
		replace them with High
that system may
		Output power supplies to
power down
		use the components. See
without warning.
		"Internal SD Module" on
		page 119.

Alert! Redundant	Memory Sparing or Memory
memory disabled!	Mirroring was enabled in the
Memory	system setup program, but
configuration	the current configuration
does not support	does not support redundant
redundant	memory. A memory module
memory.	may be faulty.

Check the memory modules for failure. See "Troubleshooting System Memory" on page 167. Reset the memory setting, if appropriate. See "Using the System Setup Program and UEFI Boot Manager" on page 57.

Alert! System	An error caused the system to	Check other system
fatal error	reboot.	messages for additional
during previous		information for possible
boot.		causes.

About Your System

41