Installing the Control Panel Assembly
WARNING: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before you begin this procedure, review the safety instructions that came with the system.
1Connect the control panel cable to the control panel board. See Figure
2Insert the control panel assembly, cable first, into the chassis. See Figure
Gently work the control panel assembly into the chassis until it is fully seated against the front of the chassis.
3Replace the Torx screw on the top side of the chassis. See Figure
4Install the outer cover on the top side of the chassis.
a Insert the cover tabs into the slots in the top side of the chassis. See Figure
b Hook the top edge of the cover over the top edge of the chassis. See Figure
c Slide the cover towards the front of the system. See Figure
d Replace the two
5Replace the Torx screw on the front of the system to secure the control panel assembly to the chassis. See Figure
6Connect the control panel cable to CTRL_PNL connector on the system board. See Figure
7Close the system. See "Closing the System" on page 86.
8Place the system upright and on its feet on a flat, stable surface.
9Rotate the system feet outward.
10Reattach any peripherals, then connect the system to the electrical outlet.
11Turn on the system and attached peripherals.
148