Dell T710 Plug & Play, Quad rank Dimm, Detected after, Single rank or, Dual rank Dimm, Socket

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
Plug & Play	Error encountered in	Install the NVRAM_CLR
Configuration	initializing PCIe device;	jumper in the clear position
Error	faulty system board.	(pins 1 and 3) and reboot the
		system. See Figure 6-1 for
		jumper location. If the
		problem persists, see
		"Troubleshooting the
		Processors" on page 179.
Quad rank DIMM	Invalid memory	Ensure that the memory
detected after	configuration.	modules are installed in a
single rank or		valid configuration. See
dual rank DIMM in		"General Memory Module
socket.		Installation Guidelines" on
		page 98.

Read fault

Requested sector not found

The operating system cannot read from the hard drive, optical drive, or USB device, the system could not find a particular sector on the disk, or the requested sector is defective.

Replace the optical medium, USB medium, or USB device. Ensure that the USB cables, SAS/SATA backplane cables, or optical drive cables are properly connected. See "Troubleshooting a USB Device" on page 160, "Troubleshooting an Optical Drive" on page 171, or "Troubleshooting a Hard Drive" on page 174 for the appropriate drive(s) installed in your system.

SATA Port x	There is no device connected Information only.
device not found	to the specified SATA port.

48

About Your System