Dell T710 Dimm mismatch, Across slots, Detected Unused memory, Detected. DIMMs, Installed

Table 1-2. System Messages (continued)

Message	Causes	Corrective Actions
Unsupported	Invalid memory	Ensure that the memory
memory	configuration. Memory	modules are installed in a
configuration.	modules are mismatched in	valid configuration. See
DIMM mismatch	the specified slots.	"General Memory Module
across slots		Installation Guidelines" on
detected:		page 98.
x,x,...
Unused memory	The memory configuration is	Reconfigure the memory for
detected. DIMMs	not optimal for mirroring or	Memory Mirroring or
installed in the	Advanced ECC Memory	Advanced ECC Memory
following	Mode. Modules in the	Mode, or change the
slot(s) are not	specified slots are unused.	memory mode to Optimized
available when in		or Sparing in the BIOS setup
Mirror mode		screen. See "System
		Memory" on page 98.
Unused memory	The memory configuration is	Reconfigure the memory for
detected. DIMMs	not optimal for mirroring or	Memory Mirroring or
installed in the	Advanced ECC Memory	Advanced ECC Memory
following	Mode. Modules in the	Mode, or change the
slot(s) are not	specified slots are unused.	memory mode to Optimized
available when in		or Sparing in the BIOS setup
128-Bit Advanced		screen. See "System
ECC mode:		Memory" on page 98.
Warning: A fatal	A fatal system error occurred	Check the SEL for
error has caused	and caused the system to	information that was logged
system reset!	reboot.	during the error. See the
Please check the		applicable troubleshooting
system event log!		section in "Troubleshooting
		Your System" on page 159 for
		any faulty components
		specified in the SEL.

About Your System

53